AS ISO 13007.5 pdf download

AS ISO 13007.5 pdf download.Ceramic tiles — Grouts and adhesives
1  Scope
This part of ISO 13007 gives terminology concerning the products, and specifies test methods (see Annex A) and values of performance requirements, for liquid-applied waterproofing products associated with tile adhesives. It specifies the evaluation of conformity and the classification and designation of liquid-applied waterproofing products beneath ceramic tiling. It is applicable to all liquid-applied waterproofing membranes — including polymer modified cementitious coatings, dispersions and reaction resin coatings — used beneath ceramic tiling for internal and external tile installations on walls and floors. NOTE  Liquid-applied waterproofing products can also be used beneath other types of tiles (natural and agglomerated stones, etc.), as long as an adverse reaction does not occur between the membrane and the alternative tile.
3  Terms and definitions
For the purposes of this document, the following terms and definitions apply.3.1 liquid-applied waterproofing membrane single- or multi component waterproofing material applied in a uniform layer or layers, beneath ceramic tiling Note 1 to entry: The final waterproofing membrane can include a reinforcing cloth or mesh. 3.2 polymer modified cementitious liquid-applied waterproofing membrane CM mixture of hydraulic binding agents, aggregates and organic additives that has only to be mixed with water or liquid admixture just before use 3.3 dispersion liquid-applied waterproofing membrane DM mixture of organic binding agent(s) in the form of an aqueous polymer dispersion, organic additives and mineral fillers Note 1 to entry: The mixture is ready for use. 3.4 reaction resin liquid-applied waterproofing membrane RM mixture of synthetic resin, mineral fillers and organic additives in which hardening occurs by chemical reaction Note 1 to entry: They are available in one or more component forms. 3.5 crack bridging ability ability of the cured waterproofing material to withstand propagation of cracks without deterioration 3.6 primer liquid coating applied to the surface, prior to the application of a liquid waterproofing product, to improve adhesion and durability of the bond between the substrate and the membrane 3.7 fundamental characteristics characteristics that a liquid-applied waterproofing membrane product always needs to have 3.8 optional characteristics characteristics for specific service conditions where enhanced levels of performance are required or which provide further information about its general performance
4  Requirements
The liquid-applied waterproofing membrane products shall comply with the characteristics specified in Table 1. Table 2 gives the additional characteristics that might be required for special service conditions. The amount of water and/or liquid admixture required for preparing the cementitious liquid-applied water waterproofing membrane shall be the same for all tests of that product.
5  Evaluation of conformity
5.1  General The liquid-applied waterproofing membrane shall be considered conformant if test results indicate compliance with all of the fundamental characteristics listed in Table 1. For those products claiming the optional classifications in Clause 5, test results must also indicate compliance with the optional characteristics listed in Table 2. 5.2  Reaction to fire Reaction to fire may be of concern in individual countries, and may need to be considered in light of local standards or regulatory requirements
6  Classification and designation
The liquid-applied waterproofing membranes are classified into one of the three types, according to the definitions given in Clause 3: CM cementitious liquid-applied waterproofing membrane; DM dispersion liquid-applied waterproofing membrane; RM reaction resin liquid-applied waterproofing membrane. For each type it is possible to have different classes, related to the different optional characteristics given in Table 2. These classes are designated by the following abbreviations: O1 with improved crack bridging ability at −5°C; O2 with improved crack bridging ability at −20°C; P resistant to contact with chlorinated water (i.e. for use in swimming pools).